"""Actual wire-junction tangency and sampled root-band curvature, no CAD trace.""" import math from build123d import Vector from OCP.BRepAdaptor import BRepAdaptor_Curve from OCP.gp import gp_Pnt,gp_Vec from OCP.GeomAbs import GeomAbs_BSplineCurve def root_band_measurements(wire,center,u,v,low,high): cutoff=low+.35*(high-low) def radius(p): q=p-center;return math.hypot(q.dot(u),q.dot(v)) endpoints=[];curves=[];straight=0 for edge in wire.edges(): for t in (0.,1.): p=edge.position_at(t) if radius(p)<=cutoff+1e-7: tangent=edge.tangent_at(t).normalized()*(1 if t==0 else -1) endpoints.append((p,tangent)) curve=BRepAdaptor_Curve(edge.wrapped) first,last=curve.FirstParameter(),curve.LastParameter() knots=[first,last] if curve.GetType()==GeomAbs_BSplineCurve: spline=curve.BSpline() knots += [spline.Knot(i) for i in range(1,spline.NbKnots()+1) if firstcutoff:continue speed=d1.Magnitude();cross=d1.Crossed(d2).Magnitude() if speed<1e-12:continue curvature=cross/(speed**3) if curvature<1e-8/max(1,high):straight+=1;continue r=1/curvature if math.isfinite(r):curves.append(r) jumps=[];unpaired=0;used=set() for i,(p,a) in enumerate(endpoints): if i in used:continue matches=[j for j,(q,b) in enumerate(endpoints) if j!=i and j not in used and (p-q).length<1e-5] if len(matches)!=1:unpaired+=1;continue j=matches[0];used.update((i,j));b=endpoints[j][1] angle=math.degrees(math.acos(max(-1,min(1,-a.dot(b))))) jumps.append({'point':list(p),'angle_deg':angle}) return {'radial_band_mm':[low,cutoff],'junction_count':len(jumps),'unpaired_endpoints':unpaired, 'max_tangent_jump_deg':max((j['angle_deg'] for j in jumps),default=None), 'worst_junctions':sorted(jumps,key=lambda j:j['angle_deg'],reverse=True)[:4], 'curvature_radius_sample_range_mm':[min(curves),max(curves)] if curves else None, 'curved_samples':len(curves),'straight_samples':straight, 'note':'在实际截面外轮廓半径较低的35%区域检查相邻边切向跳变,并按BRep曲线各样条节点区间采样一、二阶导数计算曲率半径。仅对该截面采样区域有效,不是全齿面连续性或指定刀具半径的证明。无接点/曲率采样不能视为圆角通过。'}