Sketch Offset: constrain to the ends of an offset spline (#2424) (#2615)

* claim: #2424

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01SBN24y2TcqRcm2zn8Gkj27

* Sketch Offset: constrain to the ends of an offset spline (#2424)

An associated offset spline hid all of its generated fit nodes, its two
end points included, so nothing snapped to them, and a curve drawn from
one shared the node and was refused ("invalid offset output point roles").

- An open offset's end points are shown and snapped to again; its
  interior fit nodes stay private.
- After every sketch edit, a curve that took an offset node gets its own
  point there, coincident with the node: the offset keeps sole ownership
  and the curve follows the offset when its source moves.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01SBN24y2TcqRcm2zn8Gkj27

* Scenario: lines snap to and close onto an offset spline's ends (#2424)

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01SBN24y2TcqRcm2zn8Gkj27

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
leValdemar19
2026-10-19 03:16:43 +02:00
committed by GitHub
parent c177adfceb
commit 86b2b97d6f
7 changed files with 154 additions and 3 deletions
+3
View File
@@ -129,6 +129,9 @@ error bound of 0.002 mm. Singular tangents, curvature cusps, possible self-inter
excessive subdivisions are refused. Offset these curves individually: mixed chain junctions
currently require separate geometry. `sketch.offset.break` releases an offset for independent
editing, and undo restores its association. Older independently sampled offsets remain independent.
The fit points of such an offset stay hidden, except the two ends of an open one: lines and
arcs snap to them and stay coincident with them as the offset follows its source, so the gap
between a spline and its offset can be closed into a profile.
Smooth open and newly created smooth closed offsets can be offset again, including bounded
refinement after a source edit. New closed outputs use a periodic cubic fit with continuous
tangent and curvature at the seam. Break Offset Association preserves that interpolation,