Sketch: alignment guides from any hovered point while drawing (#9105) (#9673)

* claim: #9105

* Sketch: alignment guides from any hovered point while drawing (#9105)

While a drawing tool waits for a point, hovering a line or arc end, a
rectangle corner or a free point wakes the same temporary horizontal/
vertical tracking guide as a circle centre or line midpoint. Idle
hovering keeps centres and midpoints only. Preference
sketch_tracking_points (on) turns it off.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
This commit is contained in:
PaddleStroke
2026-10-31 02:00:07 +00:00
committed by GitHub
parent 5304294107
commit cce337f83f
7 changed files with 253 additions and 44 deletions
+5 -2
View File
@@ -33,8 +33,11 @@ Hover over a circle or arc centre, or the midpoint of a straight sketch edge, th
horizontally or vertically to see a dotted alignment guide. The guide connects that reference
to the cursor's projection on the sketch axis, within the viewport; it disappears when you
move away from the axis. SolidCraft keeps the two most recent of these references and can
draw both guides. One guide on its own does not move the cursor, and endpoints are ordinary
point snaps rather than remembered references. Preferences › Sketch › **Auto snap to recent
draw both guides. One guide on its own does not move the cursor. While a drawing tool (Line,
Rectangle, Circle, Arc, Polygon, Slot, Point…) waits for a point, any sketch point is a
reference too: the end of a line or arc, a rectangle's corner, or a free point. Preferences ›
Sketch › **Alignment guides from end points and corners while drawing** turns that off and
keeps only centres and midpoints. Preferences › Sketch › **Auto snap to recent
centers and midpoints** is off until you turn it on. With it on, a drawing tool snaps the
cursor where the horizontal through one reference meets the vertical through the other. On a
rectangle, the top midpoint and a side midpoint then meet at the rectangle's centre, so that
+4 -1
View File
@@ -522,7 +522,10 @@ The guide spans the reference and cursor projection, including positions inside
The two most recent references are kept, and both guides can be drawn. A single guide does
not move the cursor. Set the preference to `false` to hide the guides. Snap suppression
(Alt, unless rebound) does the same for that gesture. Snapping the cursor to where those
guides cross is separate, and off unless `sketch_recent_snap` is true.
guides cross is separate, and off unless `sketch_recent_snap` is true. While a drawing tool
waits for a point, `sketch_tracking_points` (default true) makes every shown sketch point
other than the origin a reference too (line and arc ends, rectangle corners, free points);
`false` keeps centres and midpoints only.
### Continuous camera motion