6d410c342c
* Joints: a face or circle origin keeps its turn as the face tilts A face- or circle-centre joint origin worked out its frame's x from the normal alone (`Vec3::any_perp`), which switches axis where the normal crosses 0.9 along X: a part on a face tilted past about 64° by a parameter spun a right angle about the face. New origins keep the x they have when picked (`x`, component coordinates) and each solve lays it onto the face as it is now, so the part tilts with the face without spinning. Origins saved without it are placed as before. Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com> * Joints: origins on an edge of a face, at its middle or a corner `joint.origin` and `joint.create` take `edge: [x,y,z]` (a point on an edge of a planar face), with `on` (which face; default the larger planar face beside it) and `corner` (the end near that point). The origin sits at the edge's middle (z out of the face, y into it) or at the corner (x and y along its two edges into the face, right-handed whichever way the edges run). The edge, the face and the corner's other edge are kept by name and found again on every solve, so a part set 40 mm in from a panel's corner stays there when the panel changes size; a name that finds nothing leaves the joint out with the reason. Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com> --------- Co-authored-by: Claude Opus 5.5 (1M context) <noreply@anthropic.com> Co-authored-by: bherbruck <brennen.herbruck@gmail.com>