1999e763ab
A loop made only of arcs took the all-arcs shortcut in `offset_loop`, which
moves each arc by its radius and keeps its start and sweep angles: exact for
arcs on one circle or meeting tangentially, but where arcs of different
circles meet at a corner (a circle with lobes) the moved arcs no longer
met, and the sides were built through the wrong points without an error.
`arc_corners` moves each such corner to where the two moved circles cross,
nearest the old corner (`circles_cross`, closed form), and cuts both arcs
there. Circles that no longer cross are refused ("not supported yet"), an
arc the taper turns around closes the profile. Between the sections the
corner is a straight ruling, as for every side in `taper_loop`: on the test
profile (2.5 mm at 45°) it stays within 0.015 mm of the exact corner.
Test `tapered_extrude_of_arcs_meeting_at_corners`: the volume against the
integral of the union of the shrunk circles, 18905.42 mm³ against 18907.67
(was 18975.45).
Co-authored-by: Mariusz Pacek <pacekm90@gmail.com>
Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
Co-authored-by: bherbruck <brennen.herbruck@gmail.com>