7bdaec8f4d
* claim: #9687 * Joints: Edit Joint and Unsuppress meet a conflicting loop joint as Joint does (#9687) joint.create (#10371) turns an angle a half turn when a new loop-closing joint comes out as a conflict, so a second planar joint whose faces point the same way meets. joint.edit never did, so a design saved before that (the report's rail on two planar joints) kept the conflict however the joint was edited, and a joint unsuppressed after its part was turned away stayed one too, though Move's hint says to edit the conflicting joint. An edit that places the joint again (type, offset, angle, flip, a side, or unsuppressing it) now tries the same half turns. A rename alone moves nothing. * Joints: a loop group over the solver's values still moves the loops that need to (#9687) A frame held by many planar joints (the report's printer: six planar joints between two profiles, and more) ties its loops into one group through the shared values. Past MAX_LOOP_VALUES (64) such a group was only checked, so a new joint closing a loop in it (Joint35, the rail on the 450 mm profile, which took the group from 63 to 69 values) stayed a conflict, and nothing in the group could be driven or dragged any more. Such a group now moves the values of the loops that need to move, those open at the start or reading a held value that moves, when they are few enough, while every loop of the group stays a residual, so the others stay closed. Groups within the cap solve as before. * Joints: closed loops through a moving value follow on their own closing joint (#9687) In a loop group over the solver's values, a closed loop that runs through a value the open or driven loops move (a part slid on one planar joint and held by a second) kept its closing joint's values, so its gap opened and the solve failed. Those closing joints' values move too: they are on no tree path, so freeing them pulls in no further loop. * Joints: loops a motion link ties to a following closing joint follow too (#9687) A followed closing joint whose value a motion link sets moves the value its link chain starts from; closed loops through that value now follow on their own closing joints as well, until no more do or the values pass the solver's cap. * Joints: say what the narrowed loop solve does not find (#9687) * Joints test: measure the peg's 30 degree turn from where the loop left P0 (#9687) --------- Co-authored-by: MateuszSychXpl <151755914+MateuszSychXpl@users.noreply.github.com>