3afcd69a5c
* claim: #6211 Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> * Joints: a loop whose axes are a hair out of parallel still moves (#6211) Holes picked on parts are rarely exactly in line. A closed loop through axes a few hundredths of a microradian apart (a lever, link and a rod on a cylindrical axle) can't close exactly: it closes to nanometres, and the gap grows as it turns. The loop solver wanted 1e-7 mm, so it threw such a closure away (the loop stayed open, its parts at 0 dof) or stopped a drive or drag after a fraction of a degree. The conflict check is now 1e-4 mm / 1e-6 rad (it was below what its message can show), and joint.drive / motion and joint.reach close the loop at each step as at the start: to the tight tolerance where they get there, otherwise within the conflict check. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> --------- Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>