7b24a1dc1e
* Sketch corners: a round that would use up a whole arc is refused A quarter arc of radius 5 running into a line along it, rounded with radius 5, put the round's tangent point at the arc's other end and left an arc of no length. round_corner now skips a round whose tangent point falls on either curve's other end; with none left it says that radius does not fit, as for two lines (found by a local trim fuzzer). Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> * Sketch corners: a round where the curves meet smoothly is refused A line running on from an arc's end along its tangent (off only by rounding) has no corner, but the round's tangent points landed within 1e-7 mm of it and the round came out as an arc of no length (found by a local trim fuzzer). The corner test's line met its arc this way too and was checking that output; it now meets the arc at a corner. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> --------- Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>