Files
makeCAD/tests/kernel-cases/fillets/KNOWN_FAILING
T
jyviko 1e9e80b7a7 Wave 398/509: Tests: the fit and taper tests use geometry that still doesn't fit (and 3 more)
4 commits, squashed; the originals stay reachable from tag archive/merge-main-develop.

- c47c1d26a jyviko: Tests: the fit and taper tests use geometry that still doesn't fit
- 8c37bc756 jyviko: Fillet rig: R10 past the full round is refused naming 7.5 mm, as the case asks
- a100c7c06 jyviko: Loft rails: a station grows about its section's centroid by length, not the mean of its control points
- e5476706b jyviko: Issue 616 test: the lid's volume is its closed form, 6703.5344

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01DtL5M41G8Nua7HvuFPZkmJ
2026-10-29 22:10:22 -04:00

10 lines
1.0 KiB
Plaintext

# The fillet cases that fail today, one a line: `<case> <why it fails today>`. Sorted. The fillet
# rig gate (.github/workflows/fillet-rig.yml) fails on a case that fails and is not listed here,
# and on a listed case that passes: a fix removes its line in the same pull request.
# Baseline: develop 242bbc89f with the SMLib fixes of 2026-10-29 (integration-overnight + b78bd4a), aarch64 Linux.
1207-fillet-bar-top-edge-after-boss-arc-round-r0-5 SMLib's check refuses the round: internal coincident control points in a B-spline curve (an internal pole)
4782-fillet-bar-edge-wider-than-both-faces SMLib status 1001: a convex round past both its faces is not yet built by subtraction
5158-fillet-round-just-past-a-10mm-face SMLib status 1001: a convex round 0.01 past its face is not yet built by subtraction (10.0001-10.04 open)
9-fillet-corner-curvature-with-reduce-fit not supported yet: solid.fillet builds corner g2 with the exact fit only
9-fillet-corner-curvature-with-taper-fit not supported yet: solid.fillet builds corner g2 with the exact fit only