Files
makeCAD/crates/doc
kaltenbrunnermarkus 232a902680 Circular pattern: cutting many copies of a hole is faster (#9007) (#9038)
* claim: #9007

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Circular pattern: cut copies of a hole that lie apart in one go, and check missed copies cheaply (#9007)

The check for copies that remove no material intersected every copy with
the whole body; a point test along the hole's axis (and through the middle
of the copy's overlap with the body) now proves most copies take material
and only the rest are intersected. Copies the kernel's coarse box test
takes for meeting are measured on finer meshes and, when clearly apart,
joined with join_apart and cut once.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Format (#9007)

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Look for a copy's material through the middle of each of its faces (#9007)

A tool of two pieces (two circles cut at once) turned by 45 degrees has the
middle of its box between the pieces; the lines along the axes through it
miss both, and the copy was intersected. The lines through the middle of
each face's box run along each cylinder's axis.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Circular pattern: cut copies that notch the same round face one by one (#9007)

Copies whose boxes only finer meshes show apart were cut in one go. When
several of them notch the same curved face of the target (grooves along a
bore), the result kept extra lines on that face: a revolved ring with 37
grooves came out in 184 faces instead of the 151 a one-by-one cut leaves,
at the same volume. Such copies are now cut in turn; copies that only
share flat faces (through holes in a tube wall) are still cut at once.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Circular pattern: tell copies apart and find copies that cut nothing on exact shapes (#9007)

The checks this pull request added decided on meshes, which `cargo xtask
mesh-decisions` now refuses. They decide on the exact shapes instead:

- Two tools whose boxes meet are apart when their union comes out in two
  pieces that share no face, edge or vertex (crossing, nested and touching
  tools do not).
- A copy takes material when a point along its axis, the axes of its round
  faces or the middle of the box it shares with a target is inside both, by
  exact point classification; only copies that test cannot place are
  intersected.
- Copies that notch the same round face are no longer cut one by one: cut
  in one go they now leave the same faces as one by one (a revolved bore
  with 37 grooves: 80 faces either way, as on main).

The test of copies that come close now uses 8.5 mm, where they overlap; at
9 mm they are 0.012 mm apart and are cut in one go.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-04 18:42:02 +00:00
..