86342b8c5c
* claim: #8155 Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_019FAWPuFoh9qxn2uS2j53QZ * DXF import: an elliptical arc comes in as exact conic arcs (#8155) A partial ELLIPSE (how Fusion, and SolidCraft's own DXF export, write an elliptical arc) was read as a degree-3 spline fitted through 16 samples, which strays from the ellipse between them: 0.84 mm on a 300-degree arc of a 200 x 40 mm ellipse. It is now read as exact rational-quadratic conic pieces of at most a quarter turn each, which the sketch keeps as conics. A conic arc written by SolidCraft's DXF export now reads back as the same conic. The arc's sweep is taken with rem_euclid instead of a loop that added a turn at a time, which ran for billions of turns on a start angle of 1e11. sketch.drawing_bounds and the width/height sizing of sketch.insert_dxf measure a conic by points along it, not by its apex, which can lie outside the curve. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> Claude-Session: https://claude.ai/code/session_019FAWPuFoh9qxn2uS2j53QZ --------- Co-authored-by: Claude <noreply@anthropic.com>