Files
makeCAD/crates/engine
dudedagger42 a147a7c083 Sketch Point: a point put on a midpoint or a curve snap is held there (#4691) (#4745)
* Sketch Point: a point put on a midpoint or a curve snap is held there (#4691)

The Point tool sent only a snapped point's coordinates and sketch.point
took only [x, y], so a point clicked on a line's midpoint (or on a curve,
or a model vertex) was free to move off it. sketch.point now takes the
snap forms the other draw commands take ("mid:<line>", "on:<curve>:x,y",
{vertex}, {on_edge}); the snap makes the point with its constraint. The
tool passes those snaps as themselves; a snap to an existing point still
goes as coordinates, where `connect` joins them.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Sketch Point: refuse a snap it can't read instead of answering as if it made a point

sketch_project::snap_points leaves a snap it can't parse ("on:c1:abc",
"on:c1", "on:c1:1,2,3") as it was given, and sketch.point then read
that string back as the point it had made: no error, no point, and an id
a script would go on to dimension. It now takes the snap only when it
names a point of the sketch, and otherwise refuses, listing the snap
forms (found by the test agent on #4745).

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-10-23 13:44:42 +00:00
..