Files
makeCAD/crates/engine
rugbymauri a3f293c987 Error messages: an out-of-range value names the field that is wrong (#9625) (#9684)
* claim: #9625

Signed-off-by: Maurizio Monticelli <maurizio@whatwedo.ch>

* Name the value at fault when a hole, sheet rule, joint or extrude is refused (#9625)

Several refusals were right but named a check the input had passed, so
the user changed the wrong field:

- solid.hole: an unknown `fit` was reported as an unknown bolt size; it
  now says the fit must be close, normal or loose. A countersink angle
  out of range was reported as a countersink too narrow; the angle and
  the width are now checked apart. A `diameter` number out of range was
  reported as missing; it now gives the range, as other parameters do.
- Sheet rules: a thickness of 10000 mm or more said "must be positive";
  it now gives both limits. The K-factor and the bend radius are named
  on their own, and the message no longer implies a radius of 0 is
  refused.
- joint.drive: a number out of range said "numbers or expressions"; it
  now gives the range.
- Extrude: a distance past the kernel's limit said `end = 1000000000`;
  it now says the extrusion is too long and gives the limit.

Fixes #9625

Signed-off-by: Maurizio Monticelli <maurizio@whatwedo.ch>

* Refuse a too-long extrusion before the kernel and match the countersink floor (#9625)

The kernel is paused, and its `finite()` check also guards a revolve's
angle and a cylinder's and a torus's sizes, so its message must not say
"extrusion". crates/kernel is back as it was; the doc evaluator now
refuses an extrude (plain, tapered, or redefined from the Edit Extrude
dialog) whose end lies 10000000 mm or more from the sketch plane,
mirroring the kernel's limit, and says so. A cylinder of radius 2e7
keeps the kernel's own message.

The countersink check refused 0.1° while the message said "more than
0°". The floor stays (the cone grows as 1 / tan of the half angle) and
the message now names it: more than 0.115°.

Signed-off-by: Maurizio Monticelli <maurizio@whatwedo.ch>

---------

Signed-off-by: Maurizio Monticelli <maurizio@whatwedo.ch>
2026-11-04 18:18:14 +00:00
..