Files
makeCAD/crates
Daniel ad56dd6a93 Box window: a picked point fills Corner and Center in the design's unit (#12051) (#12052)
* Box window: a picked point fills Corner and Center in the design's unit

A vertex, edge or face picked into the Box window's Point input wrote its X, Y and Z as millimetre text whatever the design's length unit was, so an inch design showed "50.8 mm" where the other fields read inches. The fields now take the point through length_input::model, as Move and the Hole references do, so they read "2 in" there and stay "50.8 mm" in a millimetre design. The same applies to the Sphere and Torus centre.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Box window: a picked point reads to a millionth of the design's unit

length_input::model divides without rounding, so a vertex at 38.1 mm read "1.5000000000000002 in" in an inch design. length_input::shown rounds to a millionth of the design's unit, as the millimetre text did before, and the test pins that case.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

* Box window: a picked point keeps the micrometre in every design unit

length_input::shown rounds to a millionth of the design's unit, and the picked point's text is what OK sends, so in a metre design a vertex could move by up to half a millimetre. Document::design_length keeps the micrometre in every unit and still writes 38.1 mm as "1.5 in". The test now covers a metre design with a point that is not round in mm, and the Sphere and Torus centre.

Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>
2026-11-04 21:40:17 +00:00
..