Files
makeCAD/crates/engine
NOWN-DEV c177adfceb Clearance: check a shared volume against the union, allowing for the bodies' measuring error (#2090)
* Clearance: check a shared volume against the bodies and their union

An intersection can come out well formed and still wrong: one of a
mirrored pair of imported parts shared three times the volume of its
twin. The shared volume is now compared with vol(a) + vol(b) - vol(a ∪ b),
on the same (cut down) bodies; when they differ by more than 1 % (plus the
bodies' own measuring error), the pair is reported unchecked with both
numbers. Where the union gives no answer, the intersection stands.

Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com>

* Clearance: let the union cross-check allow for the bodies' measuring error

vol(a) + vol(b) - vol(a ∪ b) is a difference of measured volumes and
carries the error of all three, so correct small overlaps on large bodies
came back unchecked (0.96 mm³ where the union implied -0.75). measure
keeps a face's fine tessellation when it is within 1 % of one with a
5 times coarser chord, so a measured volume can be off by up to 0.25 %:
the allowance is now 1 % of the larger of the two answers plus 0.25 % of
the three volumes. Past it, a union that implies nothing (within that
noise of zero, or below it) while the shared part is at most a tenth of
the smaller body cannot tell, and the shared part stands. A shared part
of 412 mm³ where bodies of a few thousand imply 141 is still caught.

Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com>

* Clearance: tighten the union check's measuring allowance to 1e-4

The old note cited measure's 1 % gate, which compares face areas, not
volumes, and its 0.25 % was about 100 times the disagreement the bodies'
measures actually show. The allowance is now justified from volumes: a
curved face's chord shortfall cancels between a body and the union except
where the chord changes, which stays near 2e-5 of the three volumes; 1e-4
leaves five times that. A 40 mm roller pressed 0.2 mm into a 2 m plate
exercises it: with no allowance the pair is left unchecked (7.52 mm³
measured against 8.16 implied), with it the overlap is reported.

Co-Authored-By: Claude Opus 5.5 (1M context) <noreply@anthropic.com>

---------

Co-authored-by: Claude Opus 5.5 (1M context) <noreply@anthropic.com>
Co-authored-by: bherbruck <brennen.herbruck@gmail.com>
2026-10-18 21:16:37 -04:00
..