c9c063620a
* claim: #11103 * Hole: Bridge option for counterbores (#11103) A counterbore hole takes an optional `bridge` length: two 3D-printing layers that thick below the counterbore's floor, a slot along X across the counterbore and then a square, both 0.02 mm wider than the hole, so a printer bridges the step instead of sagging into it. Empty (the default) keeps a plain counterbore. The clearance keeps the bore, cut straight through both layers as for a plain counterbore, clear of their sides: at exactly the hole's width it ran tangent along them and broke through. The command and the geometry refuse a layer that is not a positive length, layers that don't fit in the hole below the counterbore, and a bridge on any other hole type. The Hole dialog shows a Bridge field below Drill Point for counterbores. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> * Hole: translate the Bridge label for the complete catalogs (#11103) Arabic, Hebrew, Japanese, Vietnamese and Chinese carry every English message, so `cargo xtask i18n --check` needs the new label in each. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> * Hole: bridged counterbores refuse layers past a through hole's exit, too narrow a counterbore and a malformed bridge (#11103) - Through all, the second bridge layer must end inside a body (exact point classification), short of the exit face; the tool's reach is no measure of the material. - A bridged counterbore must be at least 0.04 mm wider than the hole, so the slot's ends have room on its wall (no square root of a negative number reaches the extrude). - `solid.hole` refuses a `bridge` that is given but not a length expression (`true`, `[]`, `""`) instead of making a plain counterbore; `null` still leaves it out. - Loop2 and Seg2 now come from solidcore_record (main moved them). - The "nothing saved" check looks for the `"bridge"` key: `format_pending` names `bridged-counterbore` in every design. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> * Unit defaults test: solid.hole has the bridge field too Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> --------- Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com> Co-authored-by: bherbruck <brennen.herbruck@gmail.com>