b557f22f97
* Sketch: a construction line with a length can be a normal line (#10258) `construction: false` on a construction line command that has a `length` makes the segment a normal sketch line, ready to close a profile, instead of construction geometry. The default stays construction, and an infinite line is always construction. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> * Sketch: a length box in the construction line tools (#10258) The horizontal, vertical, parallel and perpendicular construction line tools show a Length box beside the pointer from the start. It stays empty (shown as infinite) and leaves the keyboard to the tool's shortcuts until a digit is typed; then the box takes the keyboard. Without a length the tools work as before: one click, an infinite line. With a length the first click sets the start and a second click the side the segment runs to, sent as the command's `length` and `near`, so the segment gets its length dimension. The angle tool has a Length box beside its Angle box. A typed length keeps the start's snap, and the preview draws the segment the click will create. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> * Sketch: a construction/normal switch in the construction line tools (#10258) A Construction | Normal switch sits under the Length box of the construction line tools. Normal sends `construction: false`, so a segment with a length becomes a normal sketch line, ready to close a profile, without converting it afterwards. The switch starts at Construction with each start of a tool. An infinite line is always construction, so without a length the switch is greyed out and its tooltip says why. It belongs to the tool alone: the Sketch Palette's drawing line type (X) is left as it is. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> --------- Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>