e2c9f908f8
* claim: #6569 * Sketch: an offset slot can still be moved by the dimension that places it (#6569) An offset arc is drawn round its source's own centre, and its ends are held while the sketch solves (the offset is rebuilt from its source afterwards). Its arc condition, both ends as far from the centre, then only tied that shared centre, and the source arc with it, to the middle of the held ends: a slot offset by 1 mm lost a degree of freedom, and the length that places it was refused as conflicting. The solver and the constructive reading now leave out the arc condition of an offset arc round its source's centre (Sketch::offset_arc_follows_source), as #4466 did for the Parallel between an offset line and its source. The source's own arc keeps the centre; nothing changes without an offset. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> * Sketch: a test for a rounded rectangle with an offset round it (#6569) kaievns's case from the review: the offset's corner arcs tied each corner centre to a 45 degree line, so the height followed the width and every width change was refused. Co-Authored-By: Claude Opus 5.5 <noreply@anthropic.com> --------- Co-authored-by: Claude Opus 5.5 <noreply@anthropic.com>